Küppersbusch IK320-2TCN Manuel d'utilisateur télécharger pdf (Page 3)

Cleaning the interior

Before using the appliance for the first time, wash

the interior and all internal accessories with luke-

warm water and some neutral soap so as to remove

the typical smell of a brand-new product, then dry

thoroughly.

Do not use detergents or abrasive

powders, as these will damage the finish.

USE

CONTENTS

Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2

Use - Cleaning the interior - Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3

Use - Temperature regulation - Fresh food refrigeration - Freezing fresh food - Storage of frozen food - Thawing

Ice-cube production - . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4

Use - Movable shelves - Positioning the door shelves - Hints - Hints for refrigeration - Hints for freezing - . . .5

Hints - Hints for storage of frozen food - Maintenance - Periods of no operation - Periodic cleaning . . . . .

Interior light - Defrosting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6

Customer service and spare parts - Installation - Location - Electrical connection . . . . . . . . . . . . . . . . .7

Installation - Door reversibility - Building-in instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8

• Do not place carbonated or fizzy drinks in the

freezer as it creates pressure on the container,

which may cause it to explode, resulting in

damage to the appliance.

Installation

• During normal operation, the condenser and

compressor at the back of the appliance heat up

considerably. For safety reasons, minimum

ventilation must be as shown in the relevant

Figure.

Attention: keep ventilation openings clear of

obstruction.

• If the appliance is transported horizontally, it is

possible that the oil contained in the compressor

flows in the refrigerant circuit. It is advisable to

wait at least two hours before connecting the

appliance to allow the oil to flow back in the

compressor.

• There are working parts in this product which

heat up. Always ensure that there is adequate

ventilation as a failure to do this will result in

component failure and possible food loss. See

installation instructions.

• Parts which heat up should not be exposed.

Wherever possible the back of the product should

be against a wall.

• If the appliance has been transported

horizontally, it is possible that the oil contained in

the compressor ílows in the refrigerant circuit. It

is advisable to wait at least two hours before

connecting the appliance to allow tl¦e oil to flow

back in the compressor.

Environment Protection

This appliance does not contain gasses which

could damage the ozone layer, in either its

refrigerant circuit or insulation materials. The

appliance shall not be discarded together with

the urban refuse and rubbish. Avoid damaging

the cooling unit, especially at the rear near the

heat exchanger. Information on your local

disposal sites may be obtained from municipal

authorities. The materials used on this appliance

marked by the symbol are recyclable.

Operation

Insert the plug into the wall socket.

Open the refrigerator door and turn the thermostat

knob, clockwise, beyond the «O» (STOP) position.

The appliance will start to operate. To stop

operation, simply turn the thermostat knob to

position «O»

PR266

Separate parts Ha, Hb, Hc, Hd as shown in the

figure.

Place guide (Ha) on the inside part of the furniture

door, up and down as shown in the figure and mark

the position of external holes. After having drilled

holes, fix the guide with the screws supplied.

ca. 50 mm

90°

ca. 50 mm

Fix cover (Hc) on guide (Ha) until it clips into place.

PR33

PR167

8mm

Open the appliance door and the furniture door at

90°. Insert the small square (Hb) into guide (Ha).

Put together the appliance door and the furniture

door and mark the holes as indicated in the figure.

Remove the brackets and mark a distance of 8 mm

from the outer edge of the door where the nail must

be fitted (K).

8mm

1 2 3 4 5 6

Commentaires sur ces manuels

Pas de commentaire

Küppersbusch IK320-2TCN Manuel d'utilisateur Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Réfrigérateurs-congélateurs Küppersbusch IK320-2TCN